gas grill burner replacement Installing a Temperature Gauge in a Gas Grill

Anyone who sets a price for a gas grill knows that between those who have a thermometer and those who do not have it, the price will rise significantly.With this meter, it is easier to cook than burgers and dogs and requires more barbecue time and more specific temperature.It also makes it easy to use a grill instead of an oven during the hot summer.What they don't want you to know is that you can upgrade any Grill for just $8, about 10 minutes.I bought my grill at Big Lots about four years ago!for about $60.Three years later, the burner was rusty and in very bad shape.I was going to drop a few hundred bucks on a new one, but then I decided to spend less money and a bit of work and I could get it into full working condition.I replaced the burner (I should have made a note for it but didn't think of it until later) and stained the wood part.After I replaced the lava, it was time to raise it to a new level;Better than when I bought it.This is where the thermometer is installed.For this project, you need: gas grill thermometer (available at the hardware store where the grill is sold for $8) drill bit 5/16 "drill bit (able to drill through metal) tape measure hammer nails (used to punch rails) measure the specification and surface of the grill cover to determine where to punch the rails.I decided to put mine in the center but you can put it anywhere.This step is very self-explanatory.Use your guide for drilling with nails to drill holes for gauge.The back of the gauge is secured in place with a wing nut thread.Remove the wing nut, thread the thread through the hole and tighten the wing nut on the inside of the grill cover.Now that you have the thermometer installed, it's time to enjoy it.I decided to cook a three.Tip, it requires a constant temperature between 400 and 450 degrees F.