heavy duty bbq grills How to Repair or Replace a Window Grill

The window grill is for beauty.They are installed inside and are made of plastic, vinyl or metal.They are mounted with a piece of windows, and are fixed on all sides of the door frame.They left easily when they washed the windows.All you need is a screwdriver.Check the sides, top and bottom of the grill.It may appear as a separate part, but horizontal and vertical runners connect to the frame at the top, bottom and both sides.Each of the four sides has at least two screws.There can be three or more on a longer grid.The screws enter the door frame horizontally through the side of the grille frame.It may take a slight tilt screwdriver to engage Phillips-The head of the screw.Screw all the screws.Insert the tip of the putty knife between the grille frame and the door frame.Gently pry open the grid.There may be a small rubber lip on the side.If this is the case, slide the putty knife below and pry it up to enter the crack between the frame of the grille and the door frame.If there is a crack in any mesh part, runner or frame part, you may need to purchase a new mesh part.The old one may work fine, but it makes a click if you put it back on the door.Take the grid to a glass shop and buy a replacement.Some suppliers often have stock in order to fit the standard window size.Buy different styles if you want.If you have difficulty in grilling or breaking a plastic mesh, please buy a metal mesh or a heavy mesh to stand the penalty.If the grid is exposed to direct sunlight, it is recommended to order a sun-resistant grid.Put the new mesh into the door.If it is tight, tap the grid in place at the corner with wooden blocks and hammers.If the new mesh does not have holes or does not match, use 1/16-The inch drill bit is drilled into the door frame through the guide hole.Place the original screws in the holes and drive them to secure the frame.If the mesh is broken or slightly broken and you do not want to replace or find the right mesh, glue it with silicone.Clip the end of the silicone tube from the tip down 1/4-degree angle.Run a silicone bead along the inner edge of the door frame around the perimeter of the grid fit.Press the mesh to the appropriate position and let the silicone squeeze around it.Push the broken end back into the cement.It cannot be fixed if the pieces are loose and fall off completely, but if they break on one side only, this should work properly.Put the screw back in the original hole and put it in halftight.The screw is under too much pressure and you may break the grid.Run another silicone bead on the outside of the grid, which touches the side of the frame.Before slamming the door, let the glue dry overnight.The grid exposed to direct sunlight may become rough or faded.Restore a brighter smooth surface by grinding the mesh with 180-grit sandpaper.Remove the mesh first, then polish it separately along the mesh pattern with folded sandpaper to remove the rough surface.Remove the faded color as much as possible with sandpaper.Be careful: the grid exposed to the sun will also become brittle.