sawdust charcoal briquettes How To: Turn Water into Fuel by Building This DIY Oxyhydrogen Generator

Here's how to create a sexy waterConvert your tap water into a very powerful, clean fuel generator that burns gas!An oxygen-hydrogen generator like this uses the power of the car's battery to dissolve moisture into hydrogen and oxygen gases.All in all, these fuels are more powerful than gasoline, and the only emissions released are-water!You need some stainless steel and ABS pipe fittings for this project.I visited a local manufacturing company and not only did they have a lot of scrap metal to choose from, they were even willing to help me cut it into custom sizes.A job, if I take a pair of tin scissors and a hacksaw, it will take only a few minutes to get it done.I used stainless steel of 20 specifications and with the help of their Hydraulic punch, cut the exact holes on the top and bottom of the plate.Upon completion, I have 12 plates measuring 3 "x 6" and 4 on 1-1/2 "x 6" and 3 1 "6", 4-1/2 ", 1/4 ".Use a sander to smooth down the jagged edges around the hole.Next, I polish each plate diagonally with 100 sandpaper.You can see the "X" pattern I polished on both sides of the plate.This will increase the surface area of the plate and help to produce more gas.Connect the plates together using plastic rods, plastic washers and stainless steel nuts for proper electrical connections.Then a 4 "ABS cleaning plug is attached to the top with some stainless steel bolts.I installed a rotary elbow on top of the lid and the main generator was done.Do body now.The body is made of two 4 "ABS cleaning adapters with a 4" plug on the bottom inverted and glued.The main body is a 4 "tube made of acrylic or ABS, and the generator plate and cover are screwed into the top.A similar spray made in a similar way, but needs to be clipped to the side.The clip is made of waste acrylic or ABS tubing and is glued to the side of the body.Some Poly tubes and one-A one-way check valve is added to the top elbow to ensure that the valve discharges the gas but does not return any gas.The electrolyte is distilled water, about 2-4 teaspoons of KOH.Salt or baking soda can also be used, but the dishes may be stained over time.Add the water to the bubble, then put the lid back on and connect the Poly tube.It's time to test it with a 12 volt car battery and some jumper cables.The gas is forming and I collect it in a small water bottle for testing.The gas was burning so fast that it was almost an explosion and the bottle shot down the street.Fuel becomes water, which is good for the environment.The water that already exists in this system should be able to produce thousands of litres of fuel.Just drink plenty of water!Haven't you seen the video yet?You can still see it here!Maybe you will like my other projects if you like this project.View them on www.Our friends.